DIGITAL THICKNESS GAUGE - DEAD WEIGHT TYPE - 2 KPA, 20 KPA - 0.001 X 10MM - MITUTOYO - ASTM D5199
This is a Precision Instrument for measuring the Thickness of Paper ,Plastic Film, Laminates, Foil or Board. A Digital dial gauge is mounted on the base with a Dead Weight on top so as to develop a uniform, reproducible constant pressure on the anvil through the foot
CLEAVELAND FLASH POINT APPARATUS -WITH VOLTAGE VARRIER
This apparatus is used for determination of flash point and fire point of petroleum products open cup flash between 79°C - 400°C as per specification IP 36 and IS: 1448 (P: 69) 2019. COMBINED test system either test by Gas JET or by oil wick arrangement with Voltage Varrier (Copper Coil type) control. The apparatus consists of a cup, heating plate to specific dimension thermometer clip and test flame attachment with swivel joint for passing over test liquid surface in the prescribed manner, Heating is controlled by means of Voltage Varrier fitted to the apparatus. Suitable for operation on 220 Volts 50 cycles AC Circuits. Glass Thermometer IP 28C available at extra cost. Digital Temp.indicator can also be supplied at extra cost
FREEZING POINT APPARATUS - (-70 °C) - (ASTM D1177, ASTM D2386)-
This test is particularly relevant for aviation fuels (e.g., jet fuel) where low-temperature performance is critical for safety and engine operation. As per ASTM D2386 ‑ IP 16 ‑ NFM 07048 ‑ ISO 3013 ‑ DIN 51421. The entire instrument assembly Consists of Unsilvered vacuum flask, Jacketed sample tube, Brass packing gland, Motorized stirrer, Stopper, Clamps, Refrigerated water-bath and Stand. Temperature range from -70°C to 0°C
DIGITAL REDWOOD VISCOMETER NO.1
The Redwood Viscometer is used to determine the kinematic viscosity of petroleum products and other liquid fuels. It measures the time taken for a fixed volume of liquid to flow through a calibrated orifice at a specific temperature. The test is widely used in quality control and classification of lubricating oils and fuel oils
DIGITAL REDWOOD VISCOMETER NO.2
The Redwood Viscometer is used to determine the kinematic viscosity of petroleum products and other liquid fuels. It measures the time taken for a fixed volume of liquid to flow through a calibrated orifice at a specific temperature. The test is widely used in quality control and classification of lubricating oils and fuel oils
EQUILIBRIUM REFLUX BOILING POINT TESTER OF AUTOMOTIVE HYDRAULIC BRAKE FLUID - BIS 8654
Supplied complete with Glassware, Heating unit, stand and a Glass Thermometer.
LEAKAGE TENDENCIES TESTER - ASTM D1263 - FOR WHEEL BEARING GREASE
Compliance Standards : ASTM D1263, FTM 791-3454
